REFLECTOR: Main Gear Actuator

[Rene Dugas]

One must remove the two fittings -one at each end to get the cylinder
apart.  That is usually the mistake.
Rene'

-----Original Message-----
From: reflector-bounces at tvbf.org [mailto:reflector-bounces at tvbf.org] On
Behalf Of MMurp16900 at aol.com
Sent: Monday, March 31, 2008 11:30 AM
To: reflector at tvbf.org
Subject: Re: REFLECTOR: Main Gear Actuator



Hi Jon
Try using high pressure air .
Be careful it may pop out with dangers force,
Mack
 
In a message dated 3/10/2008 11:09:03 A.M. Pacific Daylight Time,
s_korney at hotmail.com writes:

Check to see if there is a burr on the snap ring groove... That might be
holding it in...

Best... Steve



  _____  

From: jbachman at zianet.com
To: reflector at tvbf.org
Date: Mon, 10 Mar 2008 09:50:13 -0600
Subject: REFLECTOR: Main Gear Actuator



I tried to disassemble my RG STD main gear actuator to replace the seals
last night and ran into a dead end.  I removed the snap ring at the end
where the actuator shaft exits the cylinder and could not extract the
piston.  Is there something that I'm missing?

 

It is an ARO TEK actuator.

 

 

 

Jon

N956DR

 

 


  _____  

Climb to the top of the charts! Play the word scramble challenge with
star power. Play now!
<http://club.live.com/star_shuffle.aspx?icid=starshuffle_wlmailtextlink_
jan>  =

_______________________________________________
To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector

Visit the gallery!  www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives: www.tvbf.org/pipermail
Check old archives: http://www.tvbf.org/archives/velocity/maillist.html





  _____  

Create a Home Theater Like the Pros. Watch the video on AOL
<http://home.aol.com/diy/home-improvement-eric-stromer?video=15&ncid=aol
hom00030000000001> Home.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20080331/744c1c1b/attachment.htm