REFLECTOR: Main Gear Actuator

[MMurp16900 at aol.com]

Hi Jon
Try using high pressure air .
Be careful it may pop out with dangers force,
Mack
 
 
In a message dated 3/10/2008 11:09:03 A.M. Pacific Daylight Time,  
s_korney at hotmail.com writes:

Check to  see if there is a burr on the snap ring groove... That might be 
holding it  in...

Best... Steve


 
____________________________________
From: jbachman at zianet.com
To: reflector at tvbf.org
Date: Mon, 10 Mar  2008 09:50:13 -0600
Subject: REFLECTOR: Main Gear Actuator


I tried to disassemble my RG STD  main gear actuator to replace the seals 
last night and ran into a dead  end.  I removed the snap ring at the end where 
the actuator shaft exits  the cylinder and could not extract the piston.  Is 
there something that  I’m missing? 
It is an ARO TEK  actuator. 
Jon 
N956DR 



 
____________________________________
Climb to the top of the charts! Play the word scramble challenge with  star 
power. _Play now!_ 
(http://club.live.com/star_shuffle.aspx?icid=starshuffle_wlmailtextlink_jan)   =

_______________________________________________
To change your  email address, visit  
http://www.tvbf.org/mailman/listinfo/reflector

Visit the gallery!   www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives:  www.tvbf.org/pipermail
Check old archives:  http://www.tvbf.org/archives/velocity/maillist.html




**************Create a Home Theater Like the Pros. Watch the video on AOL 
Home.      
(http://home.aol.com/diy/home-improvement-eric-stromer?video=15&ncid=aolhom00030000000001)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20080331/8e31ed1f/attachment-0001.htm