REFLECTOR: Top NACA Inlets

[lawrence epstein]

I am about to put in the NACA inlets on the top. (I have an older "SE" fuselage). I am doing this by cutting out the shape, except the forward edge, then flexing the cut out down and glassing the sides. Scott sent me a template for the shape, but did not specify the depth of the inlet at the aft end.

Could someone give me the depth (measured from the outer fuselage skin to the "outside" skin or the "floor") of the inlet at the firewall?  

This is for a Standard fuselage with a Lycoming (actually, it is for the inverted Deltahawk, but will be using the same inlets)..

Thanks

Larry Epstein
173 FGE



> Date: Tue, 1 Apr 2008 17:11:59 -0700
> From: doug.holub at tx.rr.com
> To: reflector at tvbf.org
> Subject: Re: REFLECTOR: antenna mounting
> 
> I installed that same ELT a couple of weeks ago. I made a copper foil dipole with each leg the length of the external antenna. Picture attached.
> 
> ---- Lou Stedman <stedmanlou at adelphia.net> wrote: 
> > I purchased a Ameri-King AK-450 ELT from ACS to replace my old ELT. Now I need to mount an external antenna. According to the instructions a fiberglass aircraft needs a supplemental ground plane with a minimum diameter of 36". That is huge. I called the manufacturer and was told that 36" was overkill. They say 18" will do. Have any of you guys installed this unit? If so where did you install the unit and antenna and how? Thanks for your input.
> > 
> > Lou Stedman
> > Velocity N7044Q
> > Olean, NY
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20080419/22fdc97d/attachment.htm