REFLECTOR: Autopilot servos

[Peter Braswell]

Geoff
There is a torque adjustment you can do in the set up and configuration menu if you need it.  

Peter

Sent from my iPhone

On May 28, 2011, at 9:51 AM, Geoff Gerhardt <geoff at thegerhardts.com> wrote:

> Scott/John,
> 
> After playing with it a bit, and enabling altitude hold on the Dynon, I see that it give messages to trim.  Also, I ran the test procedure again with the trim adjusted right in the middle, the AP ran the pitch servo up and down over the relatively small range it uses to test successfully, so I think its functioning normal.  I'll post on the Dynon support forum just to check, tho.  Thanks.
> 
> Looking fwd to Oshkosh - hoping to be flying there next year.
> 
> Geoff
> 
> On Sat, May 28, 2011 at 10:13 AM, Scott Derrick <scott at tnstaafl.net> wrote:
> My Century AP asks me to adjust trim when the flight conditions change.  There is no way the AP is going to overpower the trim spring and flight loads.
> 
> Your training the AP as to how far it "can" move. Not testing its muscle. 
> 
> I think its functioning normally but a call to Dynon may be in order.
> 
> Scott
> 
> 
> 
> 
> -------- Original Message --------
> Subject: REFLECTOR: Autopilot servos
> From: Geoff Gerhardt <geoff at thegerhardts.com>
> To: Velocity Aircraft Owners and Builders list <reflector at tvbf.org>
> Date: 05/28/2011 05:31 AM
>> Hi all,
>> 
>> I installed my pitch autopilot servo and powered up my Dynon Skyview to get it calibrated.  The calibration process has you move the pitch to its extremes to set the endpoints.  Once calibrated, it tests the servo.  I have the Strong Pitch trim installed, so it takes quite a lot of force to overcome the         pitch trim (not sure if this is similar to the factory trim system).  Only with my help on the stick can the autopilot servo go to the extremes - is that normal?  Is it expected that the pilot will keep adjusting the pitch while on AP so the servo doesn't have to work too hard?  Or, should I put a longer lever arm on the servo to increase the torque it can deliver?
>> 
>> Thanks.
>> 
>> Geoff
>> 
>> 
>> _______________________________________________
>> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>> 
>> 
>> Visit the gallery!  www.tvbf.org/gallery
>> user:pw = tvbf:jamaicangoose
>> Check new archives: www.tvbf.org/pipermail
>> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
> 
> -- 
> One of the sanest, surest, and most generous joys of life comes from being happy over the good fortune of others.
> Robert A. Heinlein
> 
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
> 
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
> 
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
> 
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20110528/197bf1a3/attachment.htm>