REFLECTOR: Rudder Actiion

[HYTEC45 at aol.com]

In a message dated 2/22/2005 9:23:32 A.M. Pacific Standard Time,  
romott at adelphia.net writes:

1 - First place I would look is make sure the  end of the rudder nyloflow 
where it goes through the firewall is glued down  (roughen the wall of the 
nyloflow with 80 grit sand paper then epoxy with flox  it to the firewall).  The 
manual doesn't mention doing this.   If not tied down this allows the conduit to 
move and you will lose some rudder  travel.



I placed a adel clamp over the nyloflow just inside the cabin side of the  
bulkhead to accomplish the same thing.
 
TEC
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20050222/eb48204d/attachment.htm