REFLECTOR:Jeffco and strakes

[Ronnie Brown]

Hi John,
Welcome to the Reflector!  Whatcha building?  The pictures didn't make it -
must have been too big. Where do you live?

Glad to have you aboard!!!
Ronnie

----- Original Message -----
From: "John Tvedte" <JohnT@comp-sol.com>
To: <reflector@tvbf.org>
Sent: Monday, April 19, 2004 12:33 AM
Subject: RE: REFLECTOR:Jeffco and strakes


| Peel ply is the answer.  When I talked with a Tech. Support Engr. @
Jeffco - there was no mention of compatibility problems - ( he knew what I
was using it for)  Attached a couple of pics. (this is a FG airplane).
|
| -----Original Message-----
| From: reflector-admin@tvbf.org on behalf of Alex Balic
| Sent: Sun 4/18/2004 9:02 PM
| To: reflector@tvbf.org
| Cc:
| Subject: RE: REFLECTOR:Jeffco and strakes
|
|
|
| except that you can sand all of these surfaces before installation because
| they are flat sheets, after installation, there are nooks and crannies
that
| will remain glossy with structural resin when you overcoat with the
Jeffco,
| these were my areas of interest.
|
| -----Original Message-----
| From: reflector-admin@tvbf.org [mailto:reflector-admin@tvbf.org]On
| Behalf Of Fred Marconi
| Sent: Sunday, April 18, 2004 6:16 PM
| To: reflector@tvbf.org
| Subject: Re: REFLECTOR:Jeffco and strakes
|
|
|   Structural adhesive is what is used for the bid that supports the
baffles,
| the cloth that is put on the foam over the inside and outside of the
strake.
| So what they say does not make sence.
|
|
|
|
|