REFLECTOR:Cooling a canard
Chuck Jensen
reflector@tvbf.org
Tue, 16 Sep 2003 09:07:26 -0400
John,
The 10 ppm solubility is about right but I thought that was oil in water.
Is the solubility for water in oil the same?
Chuck
-----Original Message-----
From: reflector-admin@tvbf.org [mailto:reflector-admin@tvbf.org]On Behalf Of
John Dibble
Sent: Monday, September 15, 2003 7:40 PM
To: reflector@tvbf.org
Subject: Re: REFLECTOR:Cooling a canard
Chuck Jensen wrote:
> John, your right about that. My engine operates at a temp way lower than
> 190F and I get thirsty several times a day.
>
> There is one other dynamic at play here, related to moisture evaporation,
> that I'm unsure of the impact (if any). Clearly, water has a higher vapor
> pressure than oil, so it'll evaporate off more readily. However, in the
> engine, any condensation that collects in the crankcase is going to be
> covered by a thick blanket of oil which may reduce/prevent evaporation.
Yes, the blanket will slow evaporation. However water does have a small
solubility
(~10 ppm) in oil so it can slowly migrate through the oil and evaporate.
John
>
> Nonetheless, by long experience in aircraft ops, it seems that any engine
> oil temps in the +190F range is effective at driving off unwanted moisture
> and that temps of +212F is not required.
>
> The only other advantage of running higher oil temps is it implies a
hotter
> engine. Some basic physics taught us a hotter engine is more efficient
(up
> to the point that you start melting components). In addition, the high
temp
> implies less cooling and less associated drag. By my calculations, if you
> run the oil at 212F instead of 190F, considering the improved engine
> efficiency and reduced cooling drag, your overall operations will be
0.0197%
> more efficient. Of course, the speed gain of 0.101 mph from the increased
> energy conversion efficiency will require you to recalculate the timing of
> your descent so you don't overshoot the airport. Caution: Your
calculations
> may vary.
>
> Chuck Jensen
> Diversified Technologies
> 2680 Westcott Blvd
> Knoxville, TN 37931
> Phn: 865-539-9000 x25
> Cell: 865-406-9001
> Fax: 865-539-9001
> cjensen@dts9000.com
_______________________________________________
To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector
Visit the gallery! www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives: www.tvbf.org/pipermail
Check old archives: http://www.tvbf.org/archives/velocity/maillist.html