REFLECTOR:NACA inlet shape

[reflector@tvbf.org]

The kit that I have does not have the pre-molded NACA inlets for engine
cooling.  While I could purchase them from the factory, it seems that it
should be easy to make them by cutting the fuselage and use that to make
the inlet.  I think someone mentioned that the factory shape may not be
quite right.  I thought someone had a drawing or the NACA source
information on the shape and proportions.  If possible, I would like to get
the details so that I can make my own.

Jerry




CONFIDENTIALITY NOTICE: This e-mail message, including any attachments, is
for the sole use of the intended recipient(s) and may contain confidential
and privileged information or otherwise protected by law.  Any unauthorized
review, use, disclosure or distribution is prohibited.  If you are not the
intended recipient, please contact the sender by reply e-mail and destroy
all copies of the original message.