REFLECTOR: Mounting position lights
Thomas Mann via Reflector
reflector at tvbf.org
Thu Sep 25 09:08:20 CDT 2014
I would exchange that system for one that is better adapted to our construction techniques.
I used the Aveo which is held by a machine screw through the outside. I cut some thin aluminum to the profile of the light and added two nut-plates. I filled the threads with silicon and then embedded them at the mounting position followed with a couple plies of BID.
It’s easy to clean out the threads with a drill bit twisted with your fingers.
While the set you have purchased appears to be fairly nice looking, it does not lend itself well to our construction methods.
My suggestion: Bite the bullet and get something more appropriate.
T Mann
Sent from Windows Mail
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20140925/b37f8109/attachment.html>
More information about the Reflector
mailing list