REFLECTOR: Installing / drilling / aligning aileron hinges
Jorge Bujanda via Reflector
reflector at tvbf.org
Sun Nov 23 08:05:37 CST 2014
Hi Peter,
Please see the following photos and explanations for the process I used. Both complement each other. Hope these help.
http://www.jbujanda.com/ConWings_files/RUDDERS/index.html
http://www.jbujanda.com/ConWings_files/AILERONS/index.html
Regards,
Jorge Bujanda
Velocity XL FG
N478B "Dr. Tuky"
www.jbujanda.com
From: Reflector [mailto:reflector-bounces at tvbf.org] On Behalf Of Peter Braswell via Reflector
Sent: Friday, November 21, 2014 10:07 AM
To: Velocity Aircraft Owners and Builders list
Subject: REFLECTOR: Installing / drilling / aligning aileron hinges
All,
I've been scratching my head about this for a bit, thought I'd reach out to the brain trust to see what folks are doing.
I'm to the point where I have to drill and install the hinges that I fabricated for the ailerons. I was wondering how you all kept everything jigged / lined up during the process?
It seems like drilling the holes and installing the hinges with pop rivets and adhesive is easy enough to the aileron itself, but what's the best way then to align, jig and drill the holes for the screws and nut plates on the other side?
Pictures encouraged if you all have any.
TIA,
Peter
------------------------------------------------------------------------
SUDO Labs | Zuluworks.com | ThreePoint.io | CheckRide.io
"It's a Jungle Up There": www.zuluworks.com
Cell: 804.690.5896
------------------------------------------------------------------------
---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20141123/bae19ea4/attachment.html>
More information about the Reflector
mailing list