REFLECTOR: Vibration.

[John Dibble]

Think you may have an extra zero in those numbers.  Surely the blades 
don't vary by almost an inch.

John

On 5/11/2014 1:09 PM, Kurt Winker wrote:
> Placed a dial indicator against the aft face of the crush plate. Noticed a .012" difference around the no. 2 blade.
> Removed prop, checked blade thickness next to each bolt hole at the root of all 3 blades.
> Blades varied from 1.087 to 2.015. Blade 2 was thicker.
> Checked squareness of motor housing to flange while not under torque....perfect.
> Checked thickness And trueness of crush plates...perfect.
> Seems the blades are the issue.
>
> Brian, do you recall the difference in Mike Deeter's blades?
> Could just be the problem here....let's hope!  I need a fix.
>
>
>
>
> Kurt
>
> Sent from my iPad
>
> On May 10, 2014, at 17:07, Brian Michalk <michalk at awpi.com> wrote:
>
>> Just for grins before you take off the blades.  Turn the indicator 90 degrees and measure the crush plate.
>> I bet you see movement there that correlates to a thicker/thinner blade root.
>>
>>
>>
>> _______________________________________________
>> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>>
>> Visit the gallery!  www.tvbf.org/gallery
>> user:pw = tvbf:jamaicangoose
>> Check new archives: www.tvbf.org/pipermail
>> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html



---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20140511/30b5fe2b/attachment.html>