REFLECTOR: Trig TT31 Transponder Installation

[John Tvedte]

John,

I believe the serial IN on the uEncoder is used for the optional RMI compass module.  Are you sure the Serial IN on the uEncoder is wired to the GPS?  On the DB-9 connector, Pin 7, is the Serial IN.

From: reflector-bounces at tvbf.org [mailto:reflector-bounces at tvbf.org] On Behalf Of aminetech at bluefrog.com
Sent: Thursday, November 07, 2013 6:56 PM
To: Velocity Aircraft Owners and Builders list
Subject: REFLECTOR: Trig TT31 Transponder Installation

I'm getting ready to install my TT31.  My RMI encoder serial out goes to my gps.  I will reroute that to the transponder and use the repeater from the transponder to go to the gps.  I see that the "serial in" to my encoder is connected.  I assume that comes from the gps and I want to use that line to go to the transponder for ADS B out.  Can I split the gps serial out and go to both the transponder and encoder or can it only go to one or the other?  What function does the gps serial to the encoder provide?

Thanks,

John


________________________________
This message was delivered by BlueFrog.com. For the best email, please visit http://www.bluefrog.com

If you believe this message is spam, please report to abuse at bluefrog.com<mailto:abuse at bluefrog.com>.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20131108/cf2325c1/attachment.html>