REFLECTOR: Front Oil cooler size

[Paul Folkes]

Patrick,

I am also working on installing the front oil cooler at the moment.  The 2
coolers that came with my kit (an older XLRG) are Niagara Part # 20004A.
 It fits the supplied duct and NACA scoop ok.

Paul Folkes
XLRG
VH-VVX
*Building but a looooong way to go!*


On 6 November 2013 07:53, Patrick Sieders <pjsieders at comcast.net> wrote:

> Hello All,
>
>
>
> I am getting to the point where it’s time to start the forward oil cooler
> install. My airplane is upside down and I cut the hole for the cooling
> plenum. To make sure I placed it correctly I placed my oil cooler that I
> got with my engine. I now noticed that the oil cooler I have is too small
> for the opening that is on each side of the cooler.
>
>
>
> Can someone tell me which oil cooler they used (P/N). I believe that going
> to a bigger cooler will be the best bet rather than adjusting both entrance
> and exit plenum. Any thoughts ?
>
>
>
> Gr. Patrick
>
>
>
>
>
>
>
> Patrick & Dana Sieders
>
> 7244 Sugarloaf Drive
>
> Nashville TN 37211
>
>
>
> Tel. 615-250-2304
>
> Cell P. 615-918-2698
>
> Cell D. 615-918-2699
>
>
>
> Email. Js3201 at comcast.net
>
> Http://www.sieders.com/sieders
>
>
>
>
>
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20131106/ee7fb7f5/attachment.html>