REFLECTOR: Cabin heat - where to go through the bulkhead?

[Don Johnston]

Mine are directly between the rudder pedals about a inch above the floor.

The routing for the scat tubing to the co-pilot side sucks though. :-(


On Sun, Nov 3, 2013 at 7:01 PM, Reiff Lorenz <Reiff at lorenz.com> wrote:

>
>
> Where's the best place for the cabin-heat air vents to go through the
> canard bulkhead? Near the base, blowing beneath the rudder pedals? Half-way
> up the side, along the fuselage, connected to eyeball vents on the panel?
> Route the SCAT tubing over the top of the canard and don't go through the
> bulkhead? Other?
>
>
>
> I have the typically-installed nose oil cooler. Also, it's an RG, so I
> don't think I can vent the heat into the keel.
>
>
>
> I'd love to know what everyone did.
>
>
>
>
>
> *Reiff Lorenz, Dayton, OH*
>
> Velocity XL-RG, 50% complete
>
> Currently working on: Elevator trim and cabin heat
>
>
>
>
>
>
>
>
>
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20131103/afa0404e/attachment.html>