REFLECTOR: IVO Brush Modification
Michael Watson
mikewatsspg at gmail.com
Wed May 22 14:34:45 CDT 2013
John,
I would think copper running on aluminum will ware a grove in the aluminum
rings ?
The brushes are much softer and does not ware down the rings. Also, that
setup should
generate static noise in your avionics.
Mike W.
On Wed, May 22, 2013 at 1:15 PM, John Dibble <aminetech at bluefrog.com> wrote:
> I've modified the IVO brushes using 12 gauge copper wire to contact the
> hub rings. A solenoid lightly presses the wires against the rings when the
> pitch adjust switch is pressed. The white wires going to the copper wires
> serve as a spring to keep the wires from contacting the rings when no pitch
> adjustment is being made. I kept the original brushes in place to keep the
> rings clean of dirt/oil and to act as a backup in case this modification
> fails, and to supplement current transfer. This is giving me a very rapid
> pitch change (100 rpm/sec).
>
> John
>
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20130522/bda80ff0/attachment.html>
More information about the Reflector
mailing list