REFLECTOR: Adding COM Antenna after wing is built, but not finished
Scott Baker
scottb33333 at gmail.com
Wed Mar 27 03:57:11 CDT 2013
On 3/26/2013 7:39 PM, Don White wrote:
> I need to add a COM Antenna in my second winglet after the wing and
> winglet have been glassed, but not finished. Has anybody done this?
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
Adhere the di-pole copper foil antenna onto the bottom face of the
rudder winglet rib. Use a long drill bit to route/access the coax
through the nav-light channel in the wing foam (either as a 'straight
shot' from the middle of the di-pole; or down through the lower winglet
extension and then up into the nav-light cavity). Cover the installation
with a single layer of BID.
Scott B
More information about the Reflector
mailing list