REFLECTOR: Prop dia

[Ron N VelocityXLFG]

Lower RPM at higher speed.  I have a email out to Ivo to see about 
making the blades shorter . Have not heard back yet.
  From past experience they are a little slow in response.


Ron
On 6/6/2013 8:10 AM, John Dibble wrote:
> On 6/5/2013 4:13 PM, Ron N VelocityXLFG wrote:
>> I have a 72 dia prop on my  XLFG I am going to try a 76 inch Dia Ivo 
>> propeller  and  I am a little concerned with the clearance . Seems
>> like I have plenty even with a high rotation angle. Is there any 
>> other concerns or advice out there for this configuration.
>>
>> Ron
>> _______________________________________________
>> To change your email address, visit 
>> http://www.tvbf.org/mailman/listinfo/reflector
>>
>> Visit the gallery!  www.tvbf.org/gallery
>> user:pw = tvbf:jamaicangoose
>> Check new archives: www.tvbf.org/pipermail
>> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>>
> If you do have ground contact, the blades are easily repairable or you 
> can cut a little off the ends.  My 220 HP Franklin uses a 68" IVO 
> prop.  76" seems like a lot.  What is the objective?
>
> John
> _______________________________________________
> To change your email address, visit 
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html