REFLECTOR: breather augment hose
Velocity
velocityxl at fastmail.fm
Sat Aug 31 13:08:04 CDT 2013
Where did you get the High temp silicone hose . I had some attached to
my headers like you do
but the hose kept braking.
Ron
On 8/18/2013 2:33 PM, Scott Derrick wrote:
> Somebody asked about the exhaust augmenter hose and I said I would
> provide a pic.
>
> attached
>
> the light blue portion of the hose is high temp silicone. You can see
> a small aluminum heat shroud attached to the hose where the hose is
> close to the exhaust header. Not sure if the shield is really needed
> but couldn't hurt.
>
> The darker hose is connected with a short thin wall aluminum pipe,
> clamped with safety wire. That is 3/4 hose all the way, bigger is
> better. Smaller hose restricts flow and raises the pressure in the
> crankcase.
>
> The silicone hose hasn't shown any effect of heat damage in 50 hours.
>
> Scott
>
>
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20130831/428ababb/attachment.html>
More information about the Reflector
mailing list