REFLECTOR: Vacuum pump

[Mark Magee]

I just replaced mine and tried to figure a way to eliminate it... Anyone
using a venturi??? With our speed they should pull hard...
They would look a little 'retro' but would be easier than replacing these
disposable Rapcos.
Mark


On Wed, Apr 10, 2013 at 8:51 AM, Richard J. Gentil <
richard at naples-air-center.com> wrote:

> Bob,
>
> Don't forget to blow out the vacuum line and clean/replace the air filter.
>
> Richard
>
> Sent from my iPhone 5
>
> On Apr 10, 2013, at 8:38 AM, Robert  Wood <slvegl99 at aol.com> wrote:
>
> > Monday on a flight with my Velocity XL with a Lycoming IO 540 I
> experienced a vacuum pump failure. Any secrets in the procedures for
> removing and replacing it? Is the drive shaft to be lubricated when the
> replacement is installed?
> >
> > Bob Wood
> >
> > Sent from my iPad
> > _______________________________________________
> > To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
> >
> > Visit the gallery!  www.tvbf.org/gallery
> > user:pw = tvbf:jamaicangoose
> > Check new archives: www.tvbf.org/pipermail
> > Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20130410/f7a58f87/attachment.html>