REFLECTOR: Mixture/throttle cable lengths

[Scott Baker]

On 9/23/2012 6:10 PM, Geoff Gerhardt wrote:
> Guys,
>
> I've decided to replace the lever assembly the previous builder had implemented for mixture/throttle and go with the standard vernier push/pulls.
>
> Does anyone know the correct lengths for a standard velocity with an IO-360?  I'd like to put in a co-pilot throttle, too.  I'm assuming that you just run a separate, longer cable that meets up with the pilot throttle at the fuel controller linkage.  Do you use a non- locking type for the co-pilot?
>
> Thanks.
>
> Geoff
>
> Sent from my iPad
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
Non-locking type for both throttles.
Best source for the cables is the Velocity factory ... usually in stock.
Be sure to get the shim/cable clamp for the #2 throttle.
Scott B.