REFLECTOR: Epoxy question

[Lou Stedman]

I got a lot of different answers to my question about epoxy from everyone. They were much appreciated. Today I called Velocity and asked them. They told me that I used the wrong hardener, which you all told me. They said that I could use the West as long as I used the slower hardener. In my case it is the 206. He did say that the 209 would be better but if I mixed more micros, they would take away some of the heat. He also suggested that instead of trying to fill the entire void which was created, that I epoxy in close cell foam to fill the original area. He told me to let it dry using the 206 and the next day I can cut a slot just a bit larger the the horn and epoxy it into place. The last thing he suggested was to put one layer of bid over the repaired area, sand , and paint. 

So today I followed his instructions and had no problem. Tomorrow I will cut my slot and epoxy in the control horn. So not others know the “right” way to do this repair. Thanks again for all of your comments. It helped a lot.

Lou Stedman
Velocity SEFG
N7044Q
Olean, NY
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20121003/bd8dc8ca/attachment.html>