REFLECTOR: Gap between strange and wing

[Robert Wood]

Align it and get close together. A hacksaw width is OK. The idea is to avoid a bump to disturb the air flow.

Bob Wood

Sent from my iPad

On Oct 2, 2012, at 5:14 PM, Peter Braswell <peter.braswell at gmail.com> wrote:

> All,
> I'm to the point where the strake is about complete and I'm ready to flip the airplane over.  The manual doesn't go into a lot of detail and I was wondering what process or procedure folks are using to make the area where the top and bottom skin of the strakes meet the top and bottom skin of the wings?  Is there some technique to lap over and close off the entire gap or are builders just trying to get the gap and intersection as close and neat as possible?
> 
> TIA,
> Peter
> 
> ------------------------------------------------------------------------
> "It's a Jungle Up There": www.zuluworks.com
> Great Aviation Gear: www.sky-gadgets.com
> ------------------------------------------------------------------------
> 
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
> 
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20121002/4ba3f890/attachment.html>