REFLECTOR: Matco Master Cylinder
John Dibble
aminetech at bluefrog.com
Mon Jan 2 08:55:59 CST 2012
I got my brake working. I took the master cylinder apart and there was some fine black
material in the plunger area. The seals looked ok, although I don't know how I can
really tell by just looking. So I cleaned everything and reinstalled it. It works much
better than before, but still doesn't work as good as the other brake. This may be
because I don't have all the air bled out. Still, it's useable and I will fly back to MS
where I can work on it in warmer weather. When I was bleeding it, I could see a small
amount of the black material in the fluid coming out. Is this normal or is this
something I need to look into? Should the fluid be replaced every so often? I think I
will do that.
John
John Dibble wrote:
> My right brake has been a bit weak lately. My brake pads are worn, so I figured that
> was the problem. I replaced them. Today when I tried to fly, my right brake was
> hardly working at all, so I suspect the master is bad. I've ordered one from the
> factory, but would like to fly sooner if possible. Is there a way I can repair with
> local parts?
>
> John
>
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
More information about the Reflector
mailing list