REFLECTOR: Results (control Stick)
Ron N Velocity XLFG
VelocityXL at fastmail.fm
Fri Feb 24 09:44:10 CST 2012
Been a long time since I did this . As I remember there is a bearing in the Torque tube to keep
it Perpendicular. I just put a the bolt through the stick hole and through the Torque tube hole and tightened
them together with the washes between them Then made may casting.
Ron
----- Original Message -----
From: John Dibble
To: Ron N Velocity XLFG ; Velocity Aircraft Owners and Builders list
Sent: Friday, February 24, 2012 8:35 AM
Subject: Re: REFLECTOR: Results (control Stick)
That's a simple method. How did you assure the washers are perfectly perpendicular to the bolt? I rubbed my surfaces with a carbon motor brush. That gave it a slippery feel.
John
On 2/24/2012 8:19 AM, Ron N Velocity XLFG wrote:
Now that I am fling I would say that I really like the results of this modification. The only change I did
was to use one Brass washer and one Stainless steel washer to provide a better bearing surface.
Dissimilar materials helps to prevent galling. Really stiffed up the stick.
_______________________________________________
To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
Visit the gallery! www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives: www.tvbf.org/pipermail
Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20120224/cd07bc9b/attachment.htm>
More information about the Reflector
mailing list