REFLECTOR: IO-360 / Remove Slick Mag Suggestion
John Dibble
aminetech at bluefrog.com
Sun Aug 12 15:53:30 CDT 2012
On my Franklin there is not enough room to remove the screws that hold
the cap. I had to first remove the mag by pulling it back as far as it
would go and tilting it up. Then I could remove the cap screws.
John
On 8/12/2012 3:40 PM, Tom Cacek wrote:
> Be sure to pull the wire cap and assembly first (90' flat screw
> driver), that should just make it.
> -----Original Message-----
> From: Kevin Baker <flykb at verizon.net>
> To: 'Velocity Aircraft Owners and Builders list' <reflector at tvbf.org>
> Sent: Sun, Aug 12, 2012 1:30 pm
> Subject: REFLECTOR: IO-360 / Remove Slick Mag Suggestion
>
> Hi All,
> Ok.... I'm to the point I need to remove the Slick 4373 Mag from the
> back of the engine on a Velocity Elite 173
> I have 1 elec and 1 mag (mag on the right side if viewing plane from the
> rear).
> So my question is ... does anyone have any words of wisdom in getting
> this thing off. (Very tight between the mag and firewall etc, etc, etc.)
>
> Thanks,
> Kevin Baker
> N164PS
> _______________________________________________
> To change your email address, visithttp://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!www.tvbf.org/gallery <http://www.tvbf.org/gallery>
> user:pw = tvbf:jamaicangoose
> Check new archives:www.tvbf.org/pipermail <http://www.tvbf.org/pipermail>
> Check old archives:http://www.tvbf.org/archives/velocity/maillist.html
>
>
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20120812/9fa1a210/attachment.html>
More information about the Reflector
mailing list