REFLECTOR: Getting ready to close out strakes

[Douglas Holub]

I used Play-Doh. Worked great.
----- Original Message ----- 
From: "David Ullman" <ullman at robustdecisions.com>
To: <reflector at tvbf.org>
Sent: Friday, April 06, 2012 12:14 PM
Subject: REFLECTOR: Getting ready to close out strakes


> Before closing out the strakes, try this.  Put duct tape on the strakes 
> and
> the surface, where ever contact is to be made.  Then take marble sized 
> balls
> of soft clay and place them every 6 inches on all critical (outside) 
> strakes
> (I did all strakes).  Then do a dry run of mating, taping and weighting.
> This accomplishes two things: First it is a dry run.  Second, measure the
> thickness of the clay when you take the surface back off and you know the
> thickness of the adhesive.  If a ball doesn't squish at all, then you will
> have a leak.  I tried to make all the thickness near the same without 
> being
> anal by building up the strake at low points.
>
> David Ullman
> N-444DX Velocity
> EAA 292 President
> david at davidullman.com
> 541-754-3609
> 1655 NW Hillcrest Dr
> Corvallis OR 97330
>
> _______________________________________________
> To change your email address, visit 
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html