REFLECTOR: Canard incidence jig dimensions
nmflyer1 at aol.com
nmflyer1 at aol.com
Sat Nov 26 19:58:02 CST 2011
I ended up with two different incidence jigs for the main wing. Both came from the factory. Best bet is to call the factory and ask.
Kurt
-----Original Message-----
From: Matt Bucko <mbuc310 at cox.net>
To: Velocity Aircraft Owners and Builders list <reflector at tvbf.org>
Sent: Sat, Nov 26, 2011 5:07 pm
Subject: REFLECTOR: Canard incidence jig dimensions
I have 2 canard incidence jigs. Both different in sizes.
The first one, which came with the kit, had a leading end which is 3 inches from the top of the jig to where it rests on the canard. The trailing edge is 1 15/16 inch from the top to the canard resting point.
The second one I got from another Velo builder. It is "almost" the same, but different enough to make a 2 degree difference in the incidence.
The measurement of the leading end is 3 1/8 inch, and the trailing end is 1 7/8.
I do not know if the plywood is shrinking from age, or if it just a "normal" difference from the factory. Does anyone have accurate measurements of both ends...as in what it is really supposed to be?
Thanks,
Matt Bucko
Phoenix
--
_______________________________________________
o change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
Visit the gallery! www.tvbf.org/gallery
ser:pw = tvbf:jamaicangoose
heck new archives: www.tvbf.org/pipermail
heck old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20111126/323b30d3/attachment-0001.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/gif
Size: 14607 bytes
Desc: not available
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20111126/323b30d3/attachment-0001.gif>
More information about the Reflector
mailing list