REFLECTOR: Fuel Leak

[aminetech at bluefrog.com]

Scott,

I think Brian is on the same page here, he's just saying that the spot where the fuel leaks out of the tank may not be the same spot as where you're seeing it, but you will verify that when you remove the foam.

John

--- scott at tnstaafl.net wrote:

From: Scott Derrick <scott at tnstaafl.net>
To: Velocity Aircraft Owners and Builders list <reflector at tvbf.org>
Subject: Re: REFLECTOR: Fuel Leak
Date: Mon, 31 Jan 2011 10:03:11 -0700

That seems kind of fatalistic?

If I locate where the leak is and fix that location, verify it is 
fixed(no other leaks), I'm good to go.

Worrying about it leaking later from some other spot or the other wing 
is counter productive.

thanks,

Scott

-------- Original Message --------
Subject: Re: REFLECTOR: Fuel Leak
From: Brian Michalk <michalk at awpi.com>
To: Velocity Aircraft Owners and Builders list <reflector at tvbf.org>
Date: 01/31/2011 09:54 AM

> I think you should to a tank pressure test for a few days first. Then
> try to repair at the source of the leak. I have a pesky pool of oil in a
> small area from a spill years ago that I just can't get rid of. It can
> travel a long way from the initial point of the leak. So even if you
> patch up where it's coming out now, it will sure enough find another
> place to come out later.
>
> On 1/31/2011 10:43 AM, Scott Derrick wrote:
>> I think I have a dreaded fuel tank leak!
>>
>> I calibrated my fuel sensors yesterday, which involves removing the 10
>> gallons I had on board and then filling the tanks in 2 gallon
>> increments until full. First time I've had the tanks full since I
>> started this engine upgrade.
>>
>> After filling I took a short flight to shake down the 5 or 6 changes
>> I'd made(NACA augmenters, exhaust outlet diverters, crankshaft seal
>> plug(what a nightmare!), yet another oil leak fixed).. I smelled fuel
>> during the flight.
>>
>> Landed and pulled the rear seat out and couldn't see any leaks in any
>> of the plumbing, its all new, hard aluminum... Made another longer
>> flight and the smell got worse. Had to turn on the external air vents
>> and cut short a planned 1 1/2 hour flight to 1 hour. Once back on the
>> ground I was pawing around in the back and found a wet spot near the
>> fuel fitting on the right side of the fuselage. Bummer!
>>
>> I need to go down and drain that tank today, all 25 Gallons. I may
>> need to drain the other one to make the repairs.
>>
>> So I want to get the order of repair correct.
>>
>> 1.) Drain tanks, expose area(remove interior covering)
>>
>> 2.) pressurize tank with shop vac and use soap to locate hole(s). How
>> much pressure? I think the fuselage in that area is a sandwich,
>> glass-foam-glass. So do I need to grind through the inner glass and
>> foam to find the point of leakage through the fuselage outer glass,
>> which is the actual fuel tank?
>>
>> 3.) Prep area for sealing.
>>
>> 4.) Apply vacuum using shop vac to tank, apply warm epoxy, allowing
>> vacuum to suck it into hole. Not sure how long you apply the suction?
>> 1/2 an hour, until epoxy gells?
>>
>> 5.) verify fix using shop vac and soap?
>>
>> 6.) fill area with micro and apply new inner layer of glass
>>
>>
>> Is this correct?
>>
>> Scott
>>
>
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>

-- 
It is with our passions, as it is with fire and water, they are good 
servants but bad masters.
Aesop
_______________________________________________
To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector

Visit the gallery!  www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives: www.tvbf.org/pipermail
Check old archives: http://www.tvbf.org/archives/velocity/maillist.html