REFLECTOR: Another Velo in the air
Mike Dawson
medawson250 at yahoo.com
Fri Dec 2 23:13:54 CST 2011
Congrats on your flight! Now that the ailerons are rigged, I,m sure you will like it.
Mine are rigged 1/8 inch down and work great!
N104DD
Michael E Dawson
ATCI CFII
On Dec 2, 2011, at 7:30 PM, "David Ullman" <ullman at robustdecisions.com> wrote:
> I have been on the phone to Scott and am rigging the ailerons down 1/4' when
> they are loaded. I may back off a little after we convince ourselves that
> all is working OK. If down too much it makes them sluggish, but certainly
> not as scary as the current situation. I also found the another bottom
> front of the ailerons had a sharp edge on them. I didn't build these as
> some work was done on my kit prior to me getting it. Scott says this wont
> cause the "aileron snatch" (his term) that we experienced, but will make it
> worse. So, I have rounded the leading edges and reset the rigging. Will
> take it up again on Sunday and I will update you then. Note that we have
> had no wheel shimmy and the cooling seems fine (however ambient temperature
> is only about 45F).
>
>
> David Ullman
> N-444DX Velocity
> EAA 292 President
> david at davidullman.com
> 541-754-3609
>
> ***************
>
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
More information about the Reflector
mailing list