REFLECTOR: Sump tank cover
KMis178813 at aol.com
KMis178813 at aol.com
Thu Dec 23 17:33:14 CST 2010
peel-ply
In a message dated 12/23/2010 6:31:34 P.M. Eastern Standard Time,
michalk at awpi.com writes:
Was this factory supplied BID?
I bought some BID, not from Velocity that refused to conform to a surface.
It's terrible hard to work with.
But, that doesn't help you, so I would wrap the whole assembly in saran
wrap, pulling it tight. Maybe a few strips of duct tape as well.
On 12/23/2010 05:19 PM, Matt Bucko wrote:
I closed my sump and attempted to put 2 bid on the tank/lid joint. Of
course, it lifts up at the edge. I did radius the edge, however it still
lifts off. Any suggestions on keeping it down>?
Matt
_______________________________________________
To change your email address, visit
_http://www.tvbf.org/mailman/listinfo/reflector_ (http://www.tvbf.org/mailman/listinfo/reflector)
Visit the gallery! _www.tvbf.org/gallery_ (http://www.tvbf.org/gallery)
user:pw = tvbf:jamaicangoose
Check new archives: _www.tvbf.org/pipermail_
(http://www.tvbf.org/pipermail)
Check old archives: _http://www.tvbf.org/archives/velocity/maillist.html_
(http://www.tvbf.org/archives/velocity/maillist.html)
_______________________________________________
To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector
Visit the gallery! www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives: www.tvbf.org/pipermail
Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20101223/73dc8c49/attachment.htm>
More information about the Reflector
mailing list