REFLECTOR: Trim motor
Barry Gibbons
gibbons at as.net
Mon Dec 13 13:51:02 CST 2010
Hello
Chris are you using a switch in the grip? If so make sure the wire sizes and
the relay can handled the current. Mine would work when I got on the ground
but not all the time in the air. I made a trim indicator to see if it was
stopping in flight and it was stopping. I had a Ray Allen relay . I replaced
it with a trim relay board from Composite Design and it never failed after
that.
Barry
-----Original Message-----
From: reflector-bounces at tvbf.org [mailto:reflector-bounces at tvbf.org] On
Behalf Of Chris Barber
Sent: Monday, December 13, 2010 10:27 AM
To: reflector at tvbf.org
Subject: REFLECTOR: Trim motor
Is there a problem with the trim motor that I am unaware? My trim has
stopped working. I worked on it most of yesterday checking all the wires,
checking the switch (including try two different switches), verifying the
connections and schematic routings with no joy. Originally I would get
movement if I connected a batter directly to the motor, sometime through the
entire range of movement, sometimes intermentantly. However, now it has
stopped working all together.
At $280.00 a pop a new one would be very difficult right now.
Thoughts and/or solutions would be welcome. Uh, solutions other than a new
unit preferred :-)
Finally, a non engine related concern.
Chris
Sent from my iPhone 4
_______________________________________________
To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector
Visit the gallery! www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives: www.tvbf.org/pipermail
Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
More information about the Reflector
mailing list