REFLECTOR: FG sump question
Brian Michalk
michalk at awpi.com
Wed Dec 1 09:22:24 CST 2010
I rotated mine 90 degrees so that it runs along the floor, then up over
the sump and bulkhead.
On 12/1/2010 4:27 AM, Lawrence Epstein wrote:
> I have to move my fuel out port to either side. in the location on the
> fwd face of the sump, it interferes with the aileron linkage on the
> aft of the keel.
>
> Larry Epstein
>
> On Tue, Nov 30, 2010 at 9:42 PM, Matt Bucko <mbuc310 at cox.net
> <mailto:mbuc310 at cox.net>> wrote:
>
> I am ready to close out my sump tank, but have a question on the
> location of the low fuel sender hard point.
>
> Per the plans, I located the center of the hardpoint 1.5 inches
> below the top of the tank. I notice that this places the center
> of the hole, at about the same height off og the sump bottom as
> the fuel IN and vent holes.
>
> I am toying with moving the sender down an additional inch to
> eliminate the low fuel light from flickering.... If it is too near
> the top of the fuel level.
> Am I wrong to believe that the head pressure from the fuel tanks
> will fill the sump to the top?
> Matt
>
>
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery <http://www.tvbf.org/gallery>
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> <http://www.tvbf.org/pipermail>
> Check old archives:
> http://www.tvbf.org/archives/velocity/maillist.html
>
>
>
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tvbf.org/mailman/private/reflector/attachments/20101201/c7089660/attachment-0001.htm>
More information about the Reflector
mailing list