REFLECTOR: Special O-Rings

Scott Derrick scott at tnstaafl.net
Thu Jan 22 09:32:07 CST 2009


Senior moment.

The standard size has a 1/16 width and I need a 3/64, not 3/32 as I 
previously indicated?

Sorry for the confusion,

Scott

Brian Michalk wrote:
> McMaster is showing 18 products for that width and I.D.  3/8 O.D.
> 
> Scott Derrick wrote:
>> Whilst attempting to tune the turbo/induction system on a TSIO520, I 
>> found out the wastegate controller was leaking oil into the upper deck 
>> pressure side of the unit.
>>
>> I dissembled it and found the "O" rings needed replacement. not many 
>> hours on the unit but a lot of years.
>>
>> The three large rings were a standard size but the small one is not. Its 
>> close to a -008 size O-ring(3/16x5/16x1/8) but with a width of 3/32 
>> instead of 1/8 of an inch.
>>
>> I've searched and searched for an O-ring with a (3/16x5/16x3/32) but 
>> can't find one on line.
>>
>> Any suggestions?
>>
>> Scott
>> _______________________________________________
>> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>>
>> Visit the gallery!  www.tvbf.org/gallery
>> user:pw = tvbf:jamaicangoose
>> Check new archives: www.tvbf.org/pipermail
>> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>>   
> 
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
> 
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
> 


More information about the Reflector mailing list