REFLECTOR: Special O-Rings

[Brian Michalk]

McMaster is showing 18 products for that width and I.D.  3/8 O.D.

Scott Derrick wrote:
> Whilst attempting to tune the turbo/induction system on a TSIO520, I 
> found out the wastegate controller was leaking oil into the upper deck 
> pressure side of the unit.
>
> I dissembled it and found the "O" rings needed replacement. not many 
> hours on the unit but a lot of years.
>
> The three large rings were a standard size but the small one is not. Its 
> close to a -008 size O-ring(3/16x5/16x1/8) but with a width of 3/32 
> instead of 1/8 of an inch.
>
> I've searched and searched for an O-ring with a (3/16x5/16x3/32) but 
> can't find one on line.
>
> Any suggestions?
>
> Scott
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>