REFLECTOR: 2" Sanding Disks for Right Angle Grinder
Scott Derrick
scott at tnstaafl.net
Thu Jan 22 08:16:38 CST 2009
Kurt,
I'm surprised you don't go to Santa Fe Tool for sanding disks.. I've
found they have a much broader and higher quality supply.
Scott
nmflyer1 at aol.com wrote:
> Are you referring to Rol-Loc type discs?
>
> If so, my local Wal-mart carries those in the auto/airtool section. They
> are not the coursest grit, but they work. I tend to use the 3" ones even
> in a 2" arbor. I can get those in 36 60 90 etc grits from Harbor freight.
>
> Kurt
>
>
> -----Original Message-----
> From: Tom Tolton <tjtolton at charter.net>
> To: reflector at tvbf.org
> Sent: Wed, 21 Jan 2009 6:07 pm
> Subject: REFLECTOR: 2" Sanding Disks for Right Angle Grinder
>
> Any recommendations for 2” sanding disks to be used with a right angle
> die grinder. I have seen some permanently attached to a small shaft. I
> am looking for a source of supply.
>
>
>
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery <http://www.tvbf.org/gallery>
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail <http://www.tvbf.org/pipermail>
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
More information about the Reflector
mailing list