REFLECTOR: 2" Sanding Disks for Right Angle Grinder

[nmflyer1 at aol.com]

Are you referring to Rol-Loc type discs?  

If so, my local Wal-mart carries those in the auto/airtool section. They are not the coursest grit, but they work. I tend to use the 3" ones even in a 2" arbor. I can get those in 36 60 90 etc grits from Harbor freight. 

Kurt 


-----Original Message-----
From: Tom Tolton <tjtolton at charter.net>
To: reflector at tvbf.org
Sent: Wed, 21 Jan 2009 6:07 pm
Subject: REFLECTOR: 2" Sanding Disks for Right Angle Grinder




Any recommendations for 2” sanding disks to be used with a right angle die grinder.  I have seen some permanently attached to a small shaft.  I am looking for a source of supply. 

 

 




_______________________________________________
o change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
Visit the gallery!  www.tvbf.org/gallery
ser:pw = tvbf:jamaicangoose
heck new archives: www.tvbf.org/pipermail
heck old archives: http://www.tvbf.org/archives/velocity/maillist.html

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20090121/1f4eaf6f/attachment.htm