REFLECTOR: Nose Wheel Steering
Ron Brown
romott at mi-connection.com
Tue May 6 14:40:44 CDT 2008
If you have the thick washers, I think you will only have three.
With the thin ones, I think there were 6.
I run my torque between 15 - 20 lbs. Too tight and steering will be hard.
And less than 15, then you may get a shimmy.
Ronnie
----- Original Message -----
From: "Tom" <tomcat05 at comcast.net>
To: <reflector at tvbf.org>
Sent: Tuesday, May 06, 2008 3:25 PM
Subject: REFLECTOR: Nose Wheel Steering
>I like the wheel lock system. Unfortunately, I have to do an abrupt 360
> when I pull in my driveway and push the plane back. However, I'm
> building another house in the same airpark with a larger hangar and will
> re-evaluate after I move. Be curious how the cessna shimmy dampener was
> attached.
> Anyhow, I pulled the nose wheel off today and cleaned lubricated and
> reset the nut torque using a fish scale. Initial pull of 38 lbs was
> needed to move the wheel, I've got it down to 22lbs and hope this helps
> in the short term. Also, I had belleville washers on there but there was
> only 3 of them, my guess is that 4 would work better. For those using
> them how many dis you install?? thx Tom
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>
More information about the Reflector
mailing list