REFLECTOR: Main Gear Actuator
steve korney
s_korney at hotmail.com
Mon Mar 10 12:35:49 CDT 2008
Check to see if there is a burr on the snap ring groove... That might be holding it in...
Best... Steve
From: jbachman at zianet.com
To: reflector at tvbf.org
Date: Mon, 10 Mar 2008 09:50:13 -0600
Subject: REFLECTOR: Main Gear Actuator
I tried to disassemble my RG STD main gear actuator to
replace the seals last night and ran into a dead end. I removed the snap
ring at the end where the actuator shaft exits the cylinder and could not
extract the piston. Is there something that I’m missing?
It is an ARO TEK actuator.
Jon
N956DR
_________________________________________________________________
Climb to the top of the charts! Play the word scramble challenge with star power.
http://club.live.com/star_shuffle.aspx?icid=starshuffle_wlmailtextlink_jan
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20080310/8df16006/attachment-0001.htm
More information about the Reflector
mailing list