REFLECTOR: Leaking Brake Master cylinder
Brian Michalk
michalk at awpi.com
Thu Feb 14 11:38:13 CST 2008
Good question.
What's the moment arm used on these cylinders.
Desert Karts has 1/2" diameter cylinders, I think.
NMFlyer1 at aol.com wrote:
> Brian,
>
> In my MATCO paperwork it says the calipers need 450 psi of force to
> make rated torque on the brakes (600 MAX before calipers start to
> bend). What I am curious about is if the factory master cylinders have
> enough PSI for the MATCO requirement. If they are low, then an exact
> replacement would be low also.
>
> They may work, but not be developing Max. Torque.. That would mean you
> have to brake longer... = hotter.. etc.
>
> Just curious.
>
> Kurt
>
>
> In a message dated 2/14/2008 9:23:37 A.M. Mountain Standard Time,
> michalk at awpi.com writes:
>
> Are you talking about max operating pressure?
>
> pi * (5/8)^2 = 1.227 ~ 1.25 in^2
> needs 360lbs of plunger force.
>
> Same diameter as the originals, so performance would be identical.
>
>
>
>
>
> ------------------------------------------------------------------------
> The year's hottest artists on the red carpet at the Grammy Awards. AOL
> Music takes you there.
> <http://music.aol.com/grammys?NCID=aolcmp00300000002565>
> ------------------------------------------------------------------------
>
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
More information about the Reflector
mailing list