REFLECTOR: fuel sight gauge
Joe Ewen
Jewen at comporium.net
Wed Feb 13 17:41:24 CST 2008
Grigore,
Recheck the instructions that came with the units. Mine had the required resistor already installed. Mine is connected to 12V (dimmed) and remember diodes are polarity sensitive, Red=positive and Black=negative.
Joe
----- Original Message -----
From: Grigore Rosu
To: Velocity Aircraft Owners and Builders list
Sent: Wednesday, February 13, 2008 6:12 PM
Subject: REFLECTOR: fuel sight gauge
Does anybody know how to electrically install the Atkinson sight fuel gauges? In other words, can one just connect the little LED to 12V? I tried to connect it to 1.5V, then 3V and did not lit; I'm a bit affraid to expose it directly to 12V. If resistors are supposed to be serialized with the LED, does anybody know what resistors and where this info can be found?
Thank you,
Grigore
------------------------------------------------------------------------------
_______________________________________________
To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
Visit the gallery! www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives: www.tvbf.org/pipermail
Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20080213/da73f87e/attachment.htm
More information about the Reflector
mailing list