REFLECTOR: Taps and drill bits
gattenby at tulsaconnect.com
gattenby at tulsaconnect.com
Sat Sep 8 23:24:08 CDT 2007
Thanks Joe
On Sat, 8 Sep 2007 23:46:28 -0400
"Joe Ewen" <Jewen at comporium.net> wrote:
> 1/8 NPT = R
> 1/4 NPT = 7/16
> 3/8 NPT = 37/64
>
> R = 0.3390
> 21/64 = 0.3281
>
> Joe
>
> ----- Original Message -----
>From: <gattenby at tulsaconnect.com>
> To: "Velocity Aircraft Owners and Builders list"
><reflector at tvbf.org>
> Sent: Saturday, September 08, 2007 10:31 PM
> Subject: REFLECTOR: Taps and drill bits
>
>
>>
>> I'm not where I can look it up...
>>
>> I know that a 1/8 inch NPT uses an 21/64 drill bit.
>> What size drill bit do I need for
>> a 1/4 inch NPT?
>> a 3/8 inch NPT?
>>
>> I'm doing sight gauges and sump tank this weekend.
>>
>> Noel
>> _______________________________________________
>> To change your email address, visit
>> http://www.tvbf.org/mailman/listinfo/reflector
>>
>> Visit the gallery! www.tvbf.org/gallery
>> user:pw = tvbf:jamaicangoose
>> Check new archives: www.tvbf.org/pipermail
>> Check old archives:
>>http://www.tvbf.org/archives/velocity/maillist.html
>>
>
>
> _______________________________________________
> To change your email address, visit
>http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives:
>http://www.tvbf.org/archives/velocity/maillist.html
More information about the Reflector
mailing list