REFLECTOR: Aileron cable too short
Terry Miles
terrence_miles at hotmail.com
Wed Sep 5 18:08:13 CDT 2007
Al,
Thanks for this. I will check
Terry
_____
From: reflector-bounces at tvbf.org [mailto:reflector-bounces at tvbf.org] On
Behalf Of Al Gietzen
Sent: Wednesday, September 05, 2007 7:39 AM
To: 'Velocity Aircraft Owners and Builders list'
Subject: Re: REFLECTOR: Aileron cable too short
Today I tried to hook up the ailerons. After spending lots of time and
effort to get the ailerons and aileron wells just right for full aileron
travel, I have found that the aileron cable assembly is not reaching far
enough. I am hitting the travel limits of the cable.not stick travel.not
control surface binding.
Has anybody else run into this problem? Are there other ways to do this?
Terry
XL-5
The push-pull cable needs a travel of a full 3" to meet the spec for aileron
travel. One of the cables I got did; and one didn't. My solution was to
return the cable, and get one that had 3" of travel. Then with careful
alignment of bellcranks, and moving the cable clamp on one side at the keel
end, I was able to get the spec with the holes as drilled in the bellcrank.
Al
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20070905/d9078dbb/attachment-0001.htm
More information about the Reflector
mailing list