REFLECTOR: EGT Analog Gauge

Joe Ewen Jewen at comporium.net
Sat Nov 24 19:33:22 CST 2007


Scott,
Check the polarity.  With TCs, the insulation color denotes the wire type 
not the polarity.  The red wire on a K TC is the negative lead.
Joe


----- Original Message ----- 
From: "Scott Derrick" <scott at tnstaafl.net>
To: "Velocity Aircraft Owners and Builders list" <reflector at tvbf.org>
Sent: Saturday, November 24, 2007 6:00 PM
Subject: REFLECTOR: EGT Analog Gauge


>
> I installed all new probes and extension wire alone with my Dynon unit.
>
> Dynon has the hardware built in but still does not display TIT, so I
> installed an analog gauge to use whilst Dyno gets their act together.
>
> But the gauge reads nada from my TIT probe. I hooked it up to one of the
> EGT channels and the Dynon reads it fine?
>
> It was one of these, which are type K...
>
> http://www.aircraftspruce.com/catalog/inpages/falconegt.php
>
> note sure why it doesn't work..
>
> Scott
>
> -- 
>
> -
>     Truth : the most deadly weapon ever discovered by humanity. Capable
> of destroying entire perceptual sets, cultures, and realities. Outlawed
> by all governments everywhere. Possession is normally punishable by death.
>
>     Richard Childers
> _______________________________________________
> To change your email address, visit 
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
> 




More information about the Reflector mailing list