REFLECTOR: Sourcing Master Brake Cylinders
Oskar
3d_emc at earthlink.net
Sun Nov 4 16:16:09 CST 2007
Mr Michalk,
You are correct. The thread is metric. I can try to tell you the size once I get to the hanger.
(but the plunger does rotate freely, or I shall say, is not attached to the shaft that goes to the pedal.
If you still need I look and send the dimension.
Regards
Oscar
-----Original Message-----
>From: Brian Michalk <michalk at awpi.com>
>Sent: Nov 4, 2007 5:02 PM
>To: Velocity Aircraft Owners and Builders list <reflector at tvbf.org>
>Subject: REFLECTOR: Sourcing Master Brake Cylinders
>
>I'm giving up on my brake cylinders.
>I have a chronic leak, and while Juanita was going over the plans, she
>noticed that we did not have the lock nut which is supposed to keep the
>plunger from rotating.
>
>The threads in the Velocity supplied aluminum blocks don't look very
>good, and I suppose that the AL blocks are tapped for standard threads
>and the plunger is a metric thread. I think the closest die I had was
>5/16-18.
>
>Anyway, I want to find a master cylinder with SI threads. Does anyone
>have any part numbers?
More information about the Reflector
mailing list