REFLECTOR: BLUE MOUNTAIN AUTO PILOT
Tom Martino
tmartino at troubleshooter.com
Tue Jun 12 10:45:49 CDT 2007
I have done that with no joy! Thanks.
On 6/12/07 9:14 AM, "Tstockmn" <tstockmn at aol.com> wrote:
> I assume you are doing this on the ground. Change the BP setting so the
> plane thinks it's at least 2000 AGL, other wise it will not engage.
>
>
>
> In a message dated 06/09/07 21:12:48 Eastern Daylight Time,
> tmartino at troubleshooter.com writes:
>> I know there are some V-drivers with BMA EFIS systems ... So any ideas?
>>
>> I tested my auto pilot exactly as the manual instructs. I also changed out
>> the Ethernet cable (yes, I used a crossover cable). I also checked to make
>> sure the AP disconnect pin was not grounded. In fact, I do not even use the
>> DB-15 encoder plug ... so the socket is dormant.
>>
>> Still the AP disengages immediately.
>>
>> I also checked my servos (with direct voltage) ... they work.
>>
>> In my opinion, there are only two other possibilities: A bad AP controller
>> or the serial port on EFIS is not sending correct data.
>>
>> What seems more likely?
>>
>>
>> Tom
>>
>> _______________________________________________
>> To change your email address, visit
>> http://www.tvbf.org/mailman/listinfo/reflector
>>
>> Visit the gallery! www.tvbf.org/gallery
>> user:pw = tvbf:jamaicangoose
>> Check new archives: www.tvbf.org/pipermail
>> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>
>
>
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20070612/c05916ec/attachment.html
More information about the Reflector
mailing list