REFLECTOR: BLUE MOUNTAIN AUTO PILOT

[Andrew Ellzey]

Tom,

I've been looking through the installation manual and looking at the BMA 
downloads web page and I found the attached autopilot troubleshooting guide. 
Maybe this will help.

Andy


----- Original Message ----- 
From: "Tom Martino" <tmartino at troubleshooter.com>
To: "Velocity List" <reflector at tvbf.org>
Sent: Saturday, June 09, 2007 8:12 PM
Subject: REFLECTOR: BLUE MOUNTAIN AUTO PILOT


>I know there are some V-drivers with BMA EFIS systems ... So any ideas?
>
> I tested my auto pilot exactly as the manual instructs. I also changed out
> the Ethernet cable (yes, I used a crossover cable). I also checked to make
> sure the AP disconnect pin was not grounded. In fact, I do not even use 
> the
> DB-15 encoder plug ... so the socket is dormant.
>
> Still the AP disengages immediately.
>
> I also checked my servos (with direct voltage) ... they work.
>
> In my opinion, there are only two other possibilities: A bad AP controller
> or the serial port on EFIS is not sending correct data.
>
> What seems more likely?
>
>
> Tom
>
> _______________________________________________
> To change your email address, visit 
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw > Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
> 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: AP%20Application%20Note.pdf
Type: application/pdf
Size: 166815 bytes
Desc: not available
Url : http://www.tvbf.org/mailman/private/reflector/attachments/20070610/ad9d0907/attachment-0001.pdf