REFLECTOR: canard question

[Grigore Rosu]

Ken,

A 1/4 inch longer bolt and bushing would be great for me, too.  Is there any
particular place that these can be bought from?

Thank you,
Grigore

On Dec 9, 2007 1:53 PM, <KMis178813 at aol.com> wrote:

>  Grigore
>    I have found that a 1/4 inch longer bolt and bushing, installed on the
> left side for canard lift tab, works great. It will straighten the Canard
> and you will not need to mess with washers between the tab and bushing in
> the future. You do need to make sure that you always use the long bolt on
> the left side!!! I think this only applies to the SE fast build not the XL.
>
>                              Ken Mishler
>
>
>
>  ------------------------------
> Check out AOL Money & Finance's list of the hottest products<http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001>and top
> money wasters<http://money.aol.com/top5/general/ways-you-are-wasting-money?NCID=aoltop00030000000002>of 2007.
>
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20071209/c708347c/attachment.htm