REFLECTOR: Fuel resistant adhesive
Dave Philipsen
velocity at davebiz.com
Fri Dec 22 11:40:43 CST 2006
I am fashioning a homemade sniffle valve and would like some advice.
The valve is pretty simple consisting of a small nylon piece that fits
inside a couple of brass fittings. I've got it sealing pretty well when
there's suction from the engine. The nylon part seats against the brass
but it still leaks just a little bit. What I'd like to do is attach a
small piece of silicone rubber to the nylon. Hopefully, the softer
rubber will seal better against the brass. Does anyone know of an
adhesive that should remain unaffected by 100LL?
--
Dave Philipsen
Velocity STD-FG
N83DP
More information about the Reflector
mailing list