REFLECTOR: tach

[Michael Watson]

John,

The GRT EIS Tach PR requires a setting of ZERO for a six cylinder engine.
The Pulses per revolution is listed as 1.5. This is unusual because most
EI requires a setting of 3 pulses per revolution for a six cylinder engine.

Mike W.
Velocity Elite RG/ Franklin/IVO ECS



On 12/9/06, John Tvedte <johnt at comp-sol.com> wrote:
> Say - anyone know how many pulses per revolution I should get from a magneto on an IO-540? (For the tach)
>
> I was thinking I could use a DPDT switch with a GRT EIS and toggle between EI and mag, but have conflicting info.  In my case, I'm using a lightspeed III for the EI which provides 3 pulses per revolution.
>
> The GRT has to be setup with a specific P/R # - so if the EI and mag are differnt - I likely will use just the EI tach output.
>
> John
>
>
> _______________________________________________
> To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>
>


-- 
Mike W
Velocity Elite RG
Franklin /IVO Electric CS