REFLECTOR: IO 360C1C installed in a std elite rg
David Scharfenberg
dave at winco.net
Sun Aug 20 14:48:57 CDT 2006
I had to make two bumps on the lower cowl. I also had to cut a little
off of the top of the rear left cylinder, the tab where the plenum
would normally attach. My plenum had to be modified extensively.
Dave Scharfenberg
On Aug 20, 2006, at 12:32 AM, jack hayes wrote:
> I am in the process of hanging the engine and have a two spots where
> the cowling is in contact with the engine.
> The number one intake pipe is just barely touching the lower cowl and
> the plenum box above # 1 cylinder is contacting the upper cowl.
> I spoke with Scott Baker at the factory the other day and he said to
> expect some contact on this engine and to put a bulge in the cowl.
> Anyone out there with an IO360C1C in a standard elite that would have
> a comment?
> The engine is horizontally level. Number two intake is being modified
> so that should not be a problem.
> Thanks for any help you may give
> Jack
> Hayes_______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery! www.tvbf.org/gallery
> user:pw > Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: text/enriched
Size: 1668 bytes
Desc: not available
Url : http://www.tvbf.org/mailman/private/reflector/attachments/20060820/3343f7ea/attachment.bin
More information about the Reflector
mailing list